Boiler expert gives tip on how to prevent your pipes getting frozen this winter

Without doubt quite a few will want to reduce this from occurring once more, and as a consequence the boiler corporation BOXT have a option to the problem.

Households will be ready to clear up the likely trouble by placing lagging close to their pipes.

Andy Kerr, Founder at BOXT says: “Pipe lagging is the approach of insulating your h2o pipes to support avoid them freezing as the weather gets colder. It is uncomplicated, moderately cost-effective to do and with a little little bit of expertise, you can do it on your own.

Homes will want to stop their pipes bursting this winter season (Image: PA)

“Lagging, or insulating, your pipes will be certain that the warmth in your scorching water pipes is not misplaced in advance of it will get where by it is necessary. This will minimise the strength squandered, making sure the h2o carried by your pipes gets to the place it’s required though it is still hot, and helps prevent pipes from bursting. 

“According to the building regulations, the pipes that must be insulated are outside the house of the heated dwelling spot, together with people that enter vacant spaces. All most important domestic scorching h2o circulation traces. Each individual pipe main to sizzling drinking water storage containers and every secondary circulation pipeline.”

How to use lagging to prevent frozen pipes

BOXT suggests inspecting any drinking water-applying item, this sort of as your dishwasher, heating technique, or washing equipment, which may well be near to pipes.

Additionally, you must inspect any unheated spaces, these as a garage, as they are susceptible to freezing. Make certain you measure for everything considering the fact that scorching, cold, and heating pipes will will need to be lagged.

Go through Extra: How to thaw out a frozen pipe when temperatures fall

The moment you know how a lot lagging you will want you can head to your nearby Diy retail store to choose up a several bits.

This involves pipe lagging, which is made up of very long foam tubes with a hollow centre, insulation tape and a saw/knife/scissors.

BOXT provides: “Slicing the insulation tube to the appropriate length is quite straightforward. For corners to match snugly collectively you will want to slice the insulation tube at angles of 30° and 45°. You can use a mitre box to support guideline you via slicing the accurate angle in the insulation tube.

“You will also need to have to open up up the lagging lengthways (most pipe lagging has a pre-perforated slit to make this a lot easier) to let for an opening to suit in excess of your pipes. Operate your finger alongside the aspect slit to widen it so it can match your lagging. The lagging can then be inserted about your pipe.”

Thanks to the 45° angle, you can tuck it neatly driving any bends, and after you’re carried out you can seal the tube with some insulating tape.

Having said that, it is normally neater to check out and posture this to the rear of the lagging by twisting it all over soon after it can be put in on the pipe itself.